Preliminary Work And Notes On Assembly
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- If the vibration damper is to be replaced, set the concave washer/height-adjusting nut -3-
to the same position as on the old vibration damper (copy the actual dimension -X-
to the new vibration damper).
A special tool hook wrench 9647 is required for this purpose.
The special tool hook wrench 9647 is required for changing the vehicle height (dimension -X- ).
The hook wrench 9647 is used together with a torque wrench to tighten the lock nuts (grooved nuts) -2- (tightening torque: 100 Nm (74 ftlb.)).
- 3 - Height-adjusting nut/lower concave washer (grooved nut)
- 2 - Lock nut (grooved nut)/tightening torque: 100 Nm (74 ftlb.)
- X - Pre-set dimension for production: 268.5 mm (plus/minus 1 mm). The dimension may be different for the prescribed vehicle height. If the vibration damper is to be replaced, the actual dimension must be set on the new vibration damper.