| Brake lines to brake calliper (front and rear axle) |
M10 x 1 |
Tightening torque |
16 Nm (12 ftlb.) |
|
|
| Ventilation valve on brake calliper |
M10 x 1 |
Tightening torque |
14 Nm (10.5 ftlb.) |
|
|
| Connecting line to brake calliper |
M10 x 1 |
Tightening torque |
16 Nm (12 ftlb.) |
|
|
| Brake calliper to front and rear axle (PCCB and grey cast-iron brakes) |
M12 x 1.5/always use new screws on front and rear axle following removal. Different screw length on front and rear axle (see allocation in PET) |
Tightening torque |
85 Nm (63 ftlb.) |
|
|