| Wheel to wheel hub/central bolt |
All contact surfaces of the wheel, wheel hub and brake disc as well as the trapezoidal thread in the wheel hub must be free of abrasion, sand, dust or chips. Apply some aluminum paste (Optimoly TA) on the trapezoidal thread in the wheel hub if necessary. Grease the conical surface of the central bolt with a very light coating of aluminum paste before fitting each wheel. For advanced grease specifications (which are only necessary under certain conditions), refer to the description 440519 REMOVING AND INSTALLING WHEEL WITH CENTRAL BOLT
. |
3-step tightening procedure (Step 1: Tighten to 600 Nm (444 ftlb.). Step 2: Loosen the central bolt again (slightly) by approx. 90 angular degrees (1/4 turn). Step 3: Tighten to 600 Nm (444 ftlb.)). |
600 Nm |
|
|