Installing Guide Sleeve

Information 

• Before re-installation: Clean the guide sleeve, transmission input shaft and release lever, particularly at the lubrication points. 
• We recommend that you use brake cleaner as the cleaning agent. 

1. Fit guide sleeve.
   1. 1.1. Position the guide sleeve.
   2. 1.2. Tighten fastening screws -1-  . Tightening torque 24 Nm (18 ftlb.) 
      Fig 1: Identifying Screws For Guide Sleeve

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   3. 1.3. Lubricate the guide sleeve with a light coating of Kluberalfa HM83-801. Lubrication point: -arrow-  .
      Fig 2: Locating Lubrication Point

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Grease the splines of the transmission input shaft with Longtime 3EP.
3. Lubricate the contact points on the release lever with a light coating of Kluberalfa HM83-801. Lubrication points: -arrows-  .
   Fig 3: Locating Lubrication Contact Points

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Fit release lever and release bearing.
   Fig 4: Fitting Lever And Bearing

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. 4.1. -A-  : Position release lever -1-  together with the release bearing -2-  .
   2. 4.2. -B-  : Engage wire spring -3-  in the opening on the release lever from behind.