Fault code 9: Diagnosis/troubleshooting

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSIS/TROUBLESHOOTING FOR FAULT CODE 9

Work instruction			Display OK	If not OK
1	Visual inspection	Check whether the plug connections of the Targa rear window closing aid or of the control module are connected and are locked	Step 2	Connect and lock plug connections -> End
2	Check the lead from the control module to the Targa rear window closing aid for open circuit	Measure resistance between plug A on control module pin 24 and plug on the Targa rear window closing aid pin 5 Measure resistance between plug A on control module pin 25 and plug on the Targa rear window closing aid pin 5	< 5 Step 3	Repair wiring harness -> End
3	Check the lead from the Targa sliding roof micro switch to the control module for open circuit	Measure resistance between plug A on control module pin 5 and plug on the Targa rear window closing aid pin 3	< 5 Step 4	Repair wiring harness -> End
4	Replace closing aid for Targa rear window		-> End