Fault code 1: Diagnosis/troubleshooting
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS/TROUBLESHOOTING FOR FAULT CODE 1
| Work instruction | Display OK | If not OK | ||
|---|---|---|---|---|
| 1 | Check switch for Targa sliding roof |
|
Switch not actuated Switch in the direction close actuated < 5 Step 2 |
Replace switch for Targa sliding roof -> End |
| 2 | Check switch for Targa sliding roof |
|
Switch not actuated Switch in the direction open actuated < 5 Step 3 |
Replace switch for Targa sliding roof -> End |
| 3 | Check leads between the Targa sliding roof switch and the control module for short circuit to ground |
|
-> End | Repair wiring harness -> End |