LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (General Information - Electrics - 911 CARRERA (996)) >> Work instructions after disconnecting the battery >> 24 70 DME control module

24 70 DME control module

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
24 70 DME CONTROL MODULE CHART

Problem Remedy
  • After disconnection of the power supply, the idle speed might change or fluctuate briefly until the throttle adjusting unit (ME 7.8) is readapted.
  • The mixture adaptation is also lost.
After the battery is connected:
With the DME ME 7.8, it is necessary to carry out a learning and adaptation routine as described below:
  1. Switch the ignition on for 1 minute without starting the engine. Do not actuate accelerator pedal.
  2. Switch off ignition for at least 10 seconds.

    This completes the adaptation of the throttle adjusting unit.

NOTE:
  • With all DME systems, the engine must run for several minutes before the engine control module can relearn the idle speed and mixture adaptation values.