LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Seats - 911 CARRERA (996)) >> Removing and installing motor for the lumbar support >> Installing electrical line for the lumbar

Installing electrical line for the lumbar

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
ELECTRICAL LINE FOR LUMBAR INSTALLING PROCEDURE

No. Procedure Instructions
5a Electrical plug connection -5-  . See Figure . Fasten line to motor with tie wrap for the rear seat adjustment and insert plug -5-4-arrow-  . See Figure .
5b Electrical plug connection -6-  . See Figure . Join plug connection -6-  . See Figure .
6 Electrical line -7-  . See Figure . Lay line behind motor for along the lumbar support. Observe routing under the lumbar support (airbag) and along the seat frame -arrow-  . See Figure .
7 Electrical line Route the electrical line on the backrest frame parallel to the air hose -A-  . See Figure .
scientia non olet · About LEMON Manuals