Installing trim of A, B and C-pillars
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
TRIM OF A, B & C-PILLARS INSTALLING PROCEDURE (AS OF MY 1997)
| No. | Procedure | Instructions |
|---|---|---|
| 1 | Up to model year 1999; clipping in A-pillar trim | Check or replace sheet metal clips -11-12A- . See Fig 1 . |
| 2 | As of model year 2000; clipping in A-pillar trim | Note: before installation, check that the deformation element is seated properly -A-11-12B- . See Fig 1 . |
| 3 | Clipping in C-pillar trim | Check sheetmetal clips -11-10- . See Fig 1 . |
| 4 | Up to model year 1999; installing B-pillar trim -3A- . See Fig 1 . | Fasten the B-pillar trim -3A-4-6-5-50 Nm-2- . See Fig 1 . |
| 5 | As of model year 2000; installing B-pillar trim -3B- . See Fig 1 . | Push sleeve -9-3B-3B-4-6-5-50 Nm- . See Fig 1 . |
| 6 | Fitting the sash guide retaining bracket | Insert peg of the seat beat height adjuster release -8-5-8- . See Fig 1 . |
| 7 | Up to model year 2000; pushing on the clothes hook bracket -1A- . See Fig 1 . | Check both sheetmetal clips -13-1A-13-3A- . See Fig 1 . |
| 8 | As of model year 1999; pushing on the clothes hook bracket -1B- . See Fig 1 . | Check both sheetmetal clips -13-1B-1B-13-3B- . See Fig 1 . |
In the model year 2001, the seat belt height adjuster release -8- changed. The cover is now affixed on to the retaining frame. See Fig 1 .