Installing side-panel lining

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Side-Panel Lining (As Of MY 1996)

Courtesy of PORSCHE OF NORTH AMERICA, INC.

SIDE-PANEL LINING INSTALLING PROCEDURE (AS OF MY 1996)

No.	Procedure	Instructions
1	Connecting the electrical plug connections	Connect electrical plug connections -5- . See Fig 1 .
2	Side-panel lining	Position the side-panel lining -1- . See Fig 1 .
3	Tightening fastening screw	Check or renew the plug-in nut -4-3- . See Fig 1 .
4	Fitting cover	Position the locking tabs of the cover -2-arrow- . See Fig 1 .
5	Fitting seal	Lift up the pillar seal along the side-panel lining using a plastic spatula -arrow- . See Fig 1 .
	Installing B-pillar	See Removing and installing trim of A, B and C-pillars, - as of MY 1997 .