LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Linings, Insulation - 911 CARRERA (996)) >> Removing and installing roof lining >> Removing roof lining

Removing roof lining

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Roof Lining
G03106074Courtesy of PORSCHE OF NORTH AMERICA, INC.
NOTE:
ROOF LINING REMOVING PROCEDURE

No. Procedure Instructions
1 Removing interior light cover
  1. Using a small screwdriver, carefully unclip both cover lenses -1-  at the openings provided. See Fig 1 .
  2. Undo fastening screws -2-  . Unclip cover -3-  at the rear left and right, push forward towards the windscreen and remove. See Fig 1 .
  3. Disconnect the electrical plug connection of the sliding roof rocker switch -4-  and the interior light -5-  . See Fig 1 .
  Removing sun visors and brackets Refer to REMOVING AND INSTALLING SUN VISORS .
2 Unclipping front plastic lining
  1. Undo fastening screws -6-  in the plastic lining -7-  at the front and unclip the lining out of the cowl panel frame -8-  in a downward direction at the left and right. See Fig 1 .
3 Detaching roof liner at sides
  1. Unclip the metal strut of the roof liner -9-  from the plastic clips -10-  at the right and left. See Fig 1 .
4 Disengaging rear plastic lining
  1. Pull the rear plastic lining -7-  towards the rear out of the roof frame -11-  evenly on the left and right and disengage. See Fig 1 .
5 Disengaging metal strut
  1. Pull the metal brace -9-  contained in the fabric pocket down in the centre so that it bends. Pull the metal strut -12-  out of the bracket on the left and right. See Fig 1 .
6 Disengaging frame
  1. Pull the frame of the sliding roof cut-out -13-  backwards and downwards in the centre at the front so that the frame overlap at the corners is reduced and it is possible to pull it out in a downward direction. Then pull out the roof frame diagonally via the sliding roof cut-out inwards into the passenger compartment. See Fig 1 .