Installing roof lining

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Roof Lining

Courtesy of PORSCHE OF NORTH AMERICA, INC.

ROOF LINING INSTALLING PROCEDURE

No.	Procedure	Instructions
1	Checking roof lining	Note: Before installing the roof lining -1-2-3-4- . See Fig 1 .
2	Fitting frame	1. Insert the roof frame -5- diagonally from the inside via the sliding roof cut-out of the passenger compartment. At the same time, pull the frame backwards in the centre at the front of the sliding roof cut-out, so that the frame overlap at the corners is reduced and it is possible to insert the frame into the sliding roof cut-out. See Fig 1 .
3	Engaging metal strut	1. Pull the metal brace -6- contained in the fabric pocket down in the centre so that it bends. See Fig 1 . Engage the metal strut -7- in the bracket on the left and right. See Fig 1 .
4	Engaging rear plastic lining	1. Engage the rear plastic lining -2- towards the rear into the roof frame evenly on the left and right. See Fig 1 .
5	Engaging roof liner at sides	1. Engage the metal strut of the roof liner -8- into the plastic clips -9- at the left and right. See Fig 1 .
6	Clipping in plastic lining at front	1. Position the front plastic lining -2- at the left and right on the cowl panel frame -11- and clip in. Tighten the fastening screws -10- . See Fig 1 .
7	Installing brackets and sun visors	Connect the electrical plug connection of the sliding roof rocker switch -12- and the interior light -13- . See Fig 1 . Position bracket -14- on cowl panel frame and screw down with fastening screws -15- . See Fig 1 . Carefully clip cover lenses -16- . See Fig 1 .
	Installing sun visors	Refer to REMOVING AND INSTALLING SUN VISORS .