Installing roof lining (roof rail flange cover)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Roof Lining (Roof Rail Flange Cover) - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE:

Observe assembly sequence!
The cover of the rear centre panel should be stuck on first, then the cover of the roof rail flange on the left and right.

ROOF RAIL FLANGE COVER INSTALLING PROCEDURE (TARGA)

No.	Procedure	Instructions
		Before installing the covers, the flanges of the body must be cleaned.
1	Installing cover of rear centre panel	Pull protective film off the bonding areas. Position the centring notch of the cover -A1-A2- . See Fig 1 .
2	Installing roof rail flange cover on the left and right	Pull protective film off the bonding areas. -1-2-X-section C-C- . See Fig 1 . Position cover -1-2-X-section C-C- . See Fig 1 .
3	Pressing cover in below the cover of the C-pillar	Press cover in below the cover of the C-pillar -C- . See Fig 1 .