Removing and installing cowl panel cover
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
COWL PANEL COVER REMOVING AND INSTALLING PROCEDURE
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Twist lock | 2 | ||
| 2 | Battery cover | 1 | ||
| 3 | T25 Torx screw M5 x 30 | 2 | ||
| 4 | Radiator tank cover, right | 1 | ||
| 5 | Radiator tank cover, left | 1 | ||
| 6 | Dummy press-in nut | 2 | ||
| 7 | Cam | 2 | Unclip. | Clip in. |
| 8 | Cover cap | 2 | Position and press in. | With a small screwdriver. |
| 9 | T5 plastic nut | 2 | Check, replace if necessary. | |
| 10 | Torx screw T20 x 20 | 3 | ||
| 11 | Cover | 1 | ||
| 12 | Nut | 2 | Undo. | Tightening torque: -17 Nm (13 ftlb.)- |
| 13 | Left wiper arm | 1 | ||
| 14 | Right wiper arm | 1 | ||
| 15 | Cowl panel cover | 1 | ||
| 16 | Sheetmetal nut B4.8 | 3 | Adjust to centre of hole. | |
| 17 | Electrical plug connection | 2 | Press locking tabs together and separate electrical plug connection. | Connect electrical plug connection. |
| 19 | Spray nozzle | 2 | Use a screwdriver to lift the spray nozzle at the front edge. Pull off water hose. | Push on water hose and press spray nozzle into the cowl panel cover. |
| 19 | T-piece (filter element) | 1 | Twist and pull off. Remove filter element. | Clean filter element if necessary. |