LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Linings, Insulation - 911 CARRERA (996)) >> Removing and installing A-pillar trim - Cabriolet >> Installing A-pillar trim

Installing A-pillar trim

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing A-Pillar Trim (Cabriolet)
G03106072Courtesy of PORSCHE OF NORTH AMERICA, INC.
A-PILLAR TRIM INSTALLING PROCEDURE (CABRIOLET)

No. Procedure Instructions
1 Install A-pillar trim Before installation, check that the deformation element is seated properly -4-5-3-direction of the arrow-  . See Fig 1 .
2 Clip in A-pillar trim Clip in the A-pillar trim -3-direction of arrow-  . See Fig 1 .
3 Install convertible-top peg housing In order to avoid rattling noises, each of the convertible-top peg housings on the left and right -2-1-  . See Fig 1 .
scientia non olet · About LEMON Manuals