Safety instructions for work on the roll-over protection system
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- It is impermissible to perform repairs on the roll-over bar modules.
- The roll-over bar modules must be replaced in the event of visible damage or pressure marks.
WARNING:
Danger of injury during work on the roll-over protection system!
- The movement range of the roll-over protection system must be kept clear.
- Work on the roll-over protection system must be performed only with the ignition key withdrawn.
- Please note: Do not begin assembly work until after a waiting time of 1 minute has elapsed.
- Tools or other objects must not be placed in the extension area of the roll-over protection system.
WARNING:
Danger of injury during work on the roll-over protection system!
- Remove the roll-over bar modules only after the roll-over bar has been extended (triggered).
- After assembly work on the roll-over protection system - but at least every 2 years - the function of the roll-over protection system must be tested by triggering it via the diagnostic interface of the Porsche System Tester.
- Perform the function test on the roll-over protection system only with the hardtop and covering cap removed and the convertible top open.