Installing roll-over protection system
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
ROLL-OVER PROTECTION SYSTEM INSTALLATION PROCEDURE
| No. | Procedure | Instructions |
|---|---|---|
| 1 | Connect electrical plug connection | Plug in electrical plug connection of the roll-over bar modules. |
| 2 | Install roll-over bar modules |
Position the roll-over bar modules on the auxiliary frame and fasten them with the fastening screws. Only use original Porsche screws. Tightening torque. See TIGHTENING TORQUES . |
| 3 | Install cover |
Position cover of the roll-over protection system over the auxiliary frame and screw it down with the fastening screws Press locking levers of the roll-over bar modules outward, and press in the roll-over bar until it engages. |
| 4 | Trigger roll-over protection system with the Porsche System Tester |
Test the roll-over protection system (function test). Select menu item "Roll-over protection", and select menu item Drive links in the command line which then appears. Press the key combination described in the Tester; the roll-over protection system is triggered.
NOTE:
Carry out the function test only with the cover caps removed.
|
| 5 | Press in the roll-over bar | Press locking levers outward and press in the roll-over bar until it can be felt to engage. Install cover flaps on the left and right. |
| 6 | Install rear wall lining | Position rear wall lining on the auxiliary frame and fasten it on the left and right using the fastening screws. |