LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Passenger Protection - 911 CARRERA (996)) >> Removing and installing control module for roll-over protection system >> Installing control module

Installing control module

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the roll-over protection control module in the centring holes with the fixing pins, and secure with shear-off nuts.
  2. Use a 1/4 inch Allen key to tighten the shear-off nuts.
  3. Engage electrical plug connection and route wire carefully. Install control module cover, seat wells, belt buckles and centre console.
  4. Following the installation of a new control module for the roll-over protection system, the transport lock must be deactivated with the Porsche System Tester 2.
scientia non olet · About LEMON Manuals