Disassembling and assembling centre console: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
DISASSEMBLING AND ASSEMBLING PROCEDURE OF CENTRE CONSOLE
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Cover, front left | 1 | Unclip. | Clip in. |
| 2 | Clip | 28 | Check, replace if necessary | |
| 3 | Cover, centre left | 1 | Unclip. | Clip in. |
| 4 | Fastening screws | 3 | ||
| 5 | Lock support | 1 | ||
| 6 | Lock barrel | 1 | Press in the locking tabs in -inset C-6-5- . See Fig 2 . | Press the lock barrel -6-5- . See Fig 2 . |
| 7 | Plastic nut | 7 | ||
| 8 | Micro switch | 1 | From the bracket -9-inset A- . See Fig 2 . | Clip into the bracket -9- . See Fig 2 . |
| 9 | Bracket | 1 | Press the locking tabs of the bracket -9-inset B-5- . See Fig 2 . | Position bracket -9-5- . See Fig 2 . |
| 10 | Cover, rear left | 1 | Unclip. | Clip in. |
| 11 | Cover, rear top | 1 | Unclip. | Clip in. |
| 12 | Fastening screws | 4 | ||
| 13 | Extension bracket | 1 | Unscrew fastening screws -12-13- . See Fig 2 . | Position the extension bracket -13-12- . See Fig 2 . |