Disassembling and assembling cover for the oddments tray
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
ODDMENTS TRAY COVER DISASSEMBLING AND ASSEMBLING PROCEDURE
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Fastening screws | 8 | ||
| 2 | Cover, oddments tray | 1 | ||
| 3 | Fastening screws | 2 | ||
| 4 | Retaining bracket | 1 | Undo the fastening screws -3-Note:--7-4-8- . See Fig 1 . | Insert the retaining bracket -4-8-3- . See Fig 1 . |
| 5 | Hinge pin | 1 | Press the hinge pin -5-7-6- . See Fig 1 . | Position the spring -7-6-5- . See Fig 1 . |
| 6 | Lower section of oddments tray cover | 1 | ||
| 7 | Spring | 1 | ||
| 8 | Limiting band | 1 | Unclip the limiting band -8- . See Fig 1 . | Clip the retaining pin together with the limiting band -8- . See Fig 1 . |