LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Glasses, Window Control - 911 CARRERA (996)) >> Removing and installing side window >> Installing side window

Installing side window

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing Side Window Components
G03055799Courtesy of PORSCHE OF NORTH AMERICA, INC.
NOTE:
  • The removed side window can be reinstalled if:
  • there is no prior damage to the side window.
  • the side window was removed without being damaged.
SIDE WINDOW COMPONENTS INSTALLING PROCEDURE

No. Procedure Instructions
1 Fitting the rubber seal Fit the rubber seal -5-  . See Fig 1 .
2 Remove side window. Affix suction cups to the side window. Insert side window -4-direction of arrow-  . See Fig 1 .
  • 1 Keep pressing the side window -4-  upwards in -direction of arrow B-  and insert at the bottom. See Fig 1 .
  • 2 Pull the lip of the seal forward under the side window -4-  using a plastic spatula. See Fig 1 .
  • 3 Keep pressing the side window -4-  upwards in -direction of arrow B-  and insert the spacer in the retaining rail. See Fig 1 .
3 Adjusting gap dimension See Test and adjusting values  .
4 Unscrew fastening nuts and screws. Screw down the fastening screw -1-2-3-  . See Fig 1 .
  Install B and C pillars Refer to REMOVING AND INSTALLING TRIM OF A, B AND C-PILLARS, - AS OF MY 1997 .
scientia non olet · About LEMON Manuals