LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Glasses, Window Control - 911 CARRERA (996)) >> Removing and installing rear window cover - Targa >> Installing rear window cover

Installing rear window cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing Rear Window Cover Components - Targa
G03055857Courtesy of PORSCHE OF NORTH AMERICA, INC.
REAR WINDOW COVER COMPONENTS INSTALLING PROCEDURE (TARGA)

No. Procedure Instructions
1 Installing rear window cover
  1. Position rear window cover -4-  on the hinges -6-  . Make sure that the shim -8-  is positioned between the cover and the hinge. See Fig 1 .
  2. Screwing in fastening screws -3-  . See Fig 1 .
  3. Set the gap dimension -X = 15 +1 mm-  between the rear window cover -4-  and the sliding roof cover. See Fig 1 .
2 Screwing in fastening screws Set the upper edge of the hinge parallel -A-3-5-3-  . See Fig 1 .
3 Installing the pneumatic spring Place the ball socket of the pneumatic spring -2-1-  . See Fig 1 .
4 Adjusting the rear window cover Adjust the height of the rear window cover from the body by screwing the rubber pad -7-  . See Fig 1 .
    Refer to DIAGRAM - BODY GAP DIMENSIONS - TARGA .
scientia non olet · About LEMON Manuals