Removing rear power windows (Cabriolet)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Rear Power Windows (Cabriolet) Components

Courtesy of PORSCHE OF NORTH AMERICA, INC.

REAR POWER WINDOWS (CABRIOLET) COMPONENTS REMOVING PROCEDURE (STEPS 1-4)

No.	Procedure	Instructions
	Convertible top in service position	Refer to REMOVING AND INSTALLING CONVERTIBLE TOP .
	Information:	Removal and installation of the rear power window should be carried out with a rear window pane. Otherwise adjustment work is hindered during installation.
1	Removing side-panel lining	Removing side-panel lining -1- . See Fig 1 . Refer to REMOVING AND INSTALLING SIDE-PANEL LINING -- CABRIOLET, - AS OF MY 1997 .
2	Removing rear side window inner seal	Remove front and rear fastening screws -2-3- . See Fig 1 .
3	Closing side window	Press the micro-switch -4-5- . See Fig 1 .
4	Releasing power window	Release adjusting elements with the adjustment tool -7-6- . See Fig 1 .

CAUTION: Damage to or destruction of the convertible top when the convertible-top support is removed!

The convertible top must not be electrically operated when the convertible-top support is detached.

REAR POWER WINDOWS (CABRIOLET) COMPONENTS REMOVING PROCEDURE (STEPS 5-6)

No.	Procedure	Instructions
5	Detaching convertible-top support	Remove fastening screws -2-8-10-9-10-12-A = 30 mm- . See Fig 1 .
6	Removing power window	Push rear power window -11-13- . See Fig 1 .