Installing rear power windows (Cabriolet)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
REAR POWER WINDOWS (CABRIOLET) COMPONENTS INSTALLING PROCEDURE
| No. | Procedure | Instructions |
|---|---|---|
| 1 | Inserting power window | Connect electrical plug connection -13-11- . See Fig 1 . |
| 2 | Screwing down convertible-top support | Remove spacing block -12-10-2-8-10-9-2- . See Fig 1 . |
| 3,4 | Adjusting and screw down power window | By moving the power window -4-Y = +/- 10 mm-A-X =+/- 10 mm B-X = +/- 5 mm-Figure 3-B-Dimension C-Dimension D-Figure 3-E = 9 mm-Figure 4-A-A-B- . See Fig 1 . |
| 4 | Installing rear side window inner seal | Insert rear side window inner seal -3-2- . See Fig 1 . |
| 5 | Installing side-panel lining | Refer to REMOVING AND INSTALLING SIDE-PANEL LINING -- CABRIOLET, - AS OF MY 1997 . |