Installing closing aid

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing View Of Closing Aid Components - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE:

After replacing the closing aid, a reset in the Targa roof control module must be carried out. Refer to GLASSES, WINDOW CONTROL DIAGNOSIS - 911 CARRERA (996) .

CLOSING AID COMPONENTS INSTALLING PROCEDURE (TARGA)

No.	Procedure	Instructions
1	Connecting and positioning plug connection	Push on plugs -3-4-arrow- . See Fig 1 .
2	Screwing support strut in place	Engage strut on the closing aid and screw tight with the hexagon nut -2- . See Fig 1 .
3	Fitting closing aid on roof module	Fold the closing aid holder upwards in the -direction of the arrows-inset-1- . See Fig 1 .
4	Installing rear wall lining	Position cover and push on the -direction of the arrow- . See Fig 1 .