Initialization of the closing aid

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If a closing aid new is installed, it must be initialised.

Disconnect power supply for the closing aid. To do this, the central plug of the Targa roof (30-pin) must be disconnected.
- Turn plug -A- direction in and remove up and off. See Fig 1 .
- To disconnect the plug, open the locking in -B- direction. See Fig 1 .
Fig 1: Turning Plug & Opening Locking - Targa
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Reconnect power supply. Rejoin and position central plug (30-pin).
- Connect plugs, close locking -B- . See Fig 2 .
- Position plug, screw in direction of arrow -A- . See Fig 2 .
Fig 2: Connecting Plugs & Closing Locking - Targa
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Press the key Unlocking rear lid once. This re-initializes the closing aid. The control module knows the current switching position of the closing aid.