Installing styling frame: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Installing styling frame on roof frame 3
1. Screw on draught deflector -46- on the front face of the styling frame -48- with the fastening screw -47- . See Fig 1.
  Tightening torque: 1.7 Nm (1.0 ftlb.)
2. Position styling frame on roof frame 3 -8- and tighten with fastening screws -49- . See Fig 1.
  Tightening torque: 1.7 Nm (1.0 ftlb.)
Fig 1: Installing Styling Frame On Roof Frame 3
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Installing styling frame on roof frame 2
1. Screw on fabric guide plate -50- and styling frame -51- with the Torx screws T 15 -52- and the washers -52a- . See Fig 2.
  Tightening torque: 1.7 Nm (1.0 ftlb.)
2. Position styling frame -51- on roof frame 2 -5- . Adjust gap dimension -A = 3.1 ^+0.5 - between styling frames 2 and styling frame 3 -48- . Screw on fastening screws -53- and the washers -53a- . See Fig 2.
  Tightening torque: 9 Nm (7.0 ftlb.)
Fig 2: Installing Styling Frame On Roof Frame 2
Courtesy of PORSCHE OF NORTH AMERICA, INC.