Replacing potentiometer

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Cut off faulty potentiometer behind the wiring of the spare potentiometer using a pair of side cutters.

Join wires using crimp connector and crimping tool. See MATERIALS AND TOOLS .

Cut off lines to different lengths (due to the shrink connection).
Slide shrink-fit hose over the leads.
Strip 10 mm of insulation off the wires.
Connect wires with crimp connectors (do not confuse colours of the individual wires).
Shrink shrink-fit hoses with a hot-air gun. It is essential that all wires are watertight.
Wrap commercially available PVC tape all around the area of the connection points.

Installing potentiometer. See INSTALLING ELECTRICAL WIRING HARNESS .