Installing potentiometer for convertible-top interrogation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Installing and locking new contacts of the potentiometer wires
Install the new contacts of the potentiometer in the same position as follows:
Green wire (pin 1) to pin 9
Yellow wire (pin 2) to pin 4
Red wire (pin 3) to pin 8
Close the secondary lock of the plug connection with a small screwdriver again.
- Winding insulating tape around wires
- Installing potentiometer
Tighten potentiometer with fastening screws.
- Laying wire
Engage electrical plug connection.
- Installing hydraulic cylinder and rear left side-panel lining