Installing microswitch
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Install new contacts of the microswitch wires
Reinstall the new contacts of the microswitch wires in the same position and close the secondary locking of the plug connection with a small screwdriver again.
- Install and fasten upper microswitch -1-
with bracket
Turn threaded spindle until the fastening screws -2- can be screwed down with an angle screwdriver (Torx T10). See Fig 1.
- Fasten the line routing
Fasten the line under the upper microswitch with a tie wrap.
Position line in the retaining clip.
- Install lower microswitch
Install lower microswitch and fasten the fastening points (plastic) with the retaining clips or carefully heat them with a soldering iron until the material starts to flow. The microswitch must be seated firmly in the fastening points after the material cools.
- Fasten the line routing
Fasten the cable under the lower microswitch with a tie wrap.
- Install rear side section flap.