Converting hydraulic pump
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
As of middle of model year 2003 a new hydraulic pump is used. The new hydraulic pump can also be installed in all vehicles with a production date up to and including model year 2001 if the holder is also converted as well. See CONVERTING HOLDER FOR HYDRAULIC PUMP (CABRIOLET) .
HYDRAULIC PUMP CONVERSION PROCEDURE
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Electrical plug connection | 2 | Disconnect electrical plug connection, press locking tab and push out of bracket. | Push plug into bracket and make electrical plug connection. |
| 2 | Fastening nut | 3 | Unscrew. | See TIGHTENING TORQUES . |
| 2A | Silent mount | 2 | Unscrew. | |
| 7 | Bracket with hydraulic pump | 1 | Unscrew collar nuts -2- . See Fig 1. | |
| 8A | Banjo bolt | 1 | Lay cloth under banjo bolt -8A- . See Fig 1. | Push on sealing rings -9, 10-A-8A- . See Fig 1. |
| 8B | Banjo bolt | 1 | Lay cloth under hydraulic pump before unscrewing banjo bolt -8B- . See Fig 1. | Push on sealing rings -9, 10-B-8B- . See Fig 1. |
| 9 | Sealing ring A8 x 12, 1 thick | 4 | Always replace sealing ring -9- . See Fig 1. | |
| 10 | Sealing ring A8 x 12, 2 thick | 2 | Always replace sealing ring -10- . See Fig 1. | |
| 11 | Plug G 1/8 inch | 1 | ||
| 12 | Sealing ring A10 x 14, 1 thick | 1 | Always replace sealing ring -12- . See Fig 1. |