Tools and materials
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
The following tools and materials are required to construct the fixture for work in the inner area.
HARDTOP ASSEMBLY FIXTURE TOOLS AND MATERIALS (INNER AREA)
| Item | Designation | Explanation |
|---|---|---|
| Drill | ||
| Drill bit 6 mm | ||
| Drill bit 3 mm | ||
| Sabre saw | ||
| Tape measure | ||
| -B- . See Figure. | Support cheek (2x) | Multiplex plate 25 mm thick, 600 x 120 mm |
| -C- . See Figure. | Swivel arm (1x) | Multiplex plate 25 mm thick, 550 x 200 mm |
| -D- . See Figure. | Base plate (1x) | Wood-core plywood 19 mm thick, 1500 x 900 mm |
| -E- . See Figure. | Boom (1x) | Hardwood block 30 mm thick, 650 x 50 mm |
| -F- . See Figure. | Support (1x) | Hardwood block 50 mm thick, 90 x 140 x 190 mm |
| All materials listed are commercially available. | ||
| Set of fittings includes: | ||
| -A1- . See Figure. | Bracket (1x) | |
| -A2- . See Figure. | Hinge (1x) | |
| -A3- . See Figure. | Contact surface (2x) | |
| -A4- . See Figure. | Cylindrical pin 6 M6 x 40 (6x) | |
| -A5- . See Figure. | Countersunk screw 4.5 x 20 (8x) | |
| -A6- . See Figure. | Countersunk screw 6 x 20 (2x) | |
| -A7- . See Figure. | Countersunk screw 6 x 20 with disc (4x) | |
| -A8- . See Figure. | Countersunk screw 6 x 60 (2x) | |
| -A9- . See Figure. | Countersunk screw 6 x 50 (3x) | |