Making swivel arm

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Make swivel arm -C- with basic material Multiplex plate 550 x 200 mm, 25 mm thick.

Fig 1: Identifying Dimensions For Making Swivel Arm

Courtesy of PORSCHE OF NORTH AMERICA, INC.

Work procedure:
1. Fit bracket -A1- with 2 countersunk screws -A6- following the dimensions specified on the swivel arm -C- . See Fig 1.
2. Fit hinge -A2- with 4 countersunk screws -A5- following the dimensions specified on the swivel arm -C- . See Fig 1.