Fitting swivel and support cheeks on the base plate

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fit swivel arm -C- and support cheeks -B- on the base plate -D- . See Fig 1.

Basic material: Wood-core plywood 1500 x 900 mm, 19 mm thick

Fig 1: Identifying Dimensions For Fitting Swivel And Support Cheeks On Base Plate

Courtesy of PORSCHE OF NORTH AMERICA, INC.

Work procedure:
During assembly, all parts are positioned from the centre!
1. Measure and mark the base plate -D- . See Fig 1.
2. Fasten completed swivel arm -C- on the hinge -A2- with four 4.5 x 20 countersunk screws in accordance with the dimensions specified on the base plate -D- . See Fig 1.
3. Transfer hole pattern of the support cheeks -B- onto the base plate -D- in accordance with the specified dimensions, and drill holes using a 6-mm drill bit. See Fig 1.
4. Fit support cheeks -B- over the prefitted straight pins -A4- onto the base plate -D- . See Fig 1.