Fitting boom and support on the base plate

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fit boom -E- and support -F- on the base plate -D- . See Fig 1.

Fig 1: Identifying Dimensions For Fitting Boom And Support On Base Plate

Courtesy of PORSCHE OF NORTH AMERICA, INC.

Place boom in the centre!

Measure and mark the base plate -D- . See Fig 1.
Fit boom -E- on the base plate -D- with the three countersunk screws -A9- in accordance with the specified dimensions. See Fig 1.
Fit support -F- on the boom -E- with the two countersunk screws -A8- in accordance with the specified dimensions. See Fig 1.