Test and adjustment values
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
TEST AND ADJUSTMENT VALUES CHART
| Designation | Dimension | Note | |
|---|---|---|---|
| Rear side parts to the assembly aid, centre of peg on the rear side section on the inside. | -A- . See Figure. | 135 mm | Illustrated in procedure 1 |
| The upper fastening point, centre of hole for convertible-top support (rear side part on inside), to the assembly aid. | -B- . See Figure. | 118 mm | Illustrated in procedure 1 |
| Centre of assembly aid peg to lower edge of convertible-top peg housing on inside. | -C- . See Figure. | 1064 mm | Illustrated in procedure 1 |
| Check dimension from the styling edge, roof frame 1, lower edge diagonal to styling edge, roof frame 3, upper edge, rear | -E- . See Figure. | 1024 +/- 2 mm | Illustrated in procedure 3 |