Removing mounting unit (drive mechanism)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
MOUNTING UNIT (DRIVE MECHANISM) COMPONENTS REMOVING PROCEDURE - TARGA
| No. | Procedure | Instructions |
|---|---|---|
| Removing roof module | See Removing roof module . | |
| Building up roof module on device | See Tools and materials . | |
| Removing cover for sliding roof | See Removing and installing cover for sliding roof - Targa . | |
| Removing frame for sliding roof cover | See Removing and installing frame for sliding roof cover - Targa . | |
| Removing fabric lining | See Removing and installing fabric lining - Targa . | |
| 1 | Removing rear water drainage bracket | Unscrew the fastening screw -2-1-3- . See Fig 1. |
| 2 | Undoing the bracket on the rear water drainage all the way round with a metal spatula | Undo the bracket on the rear water drainage -3- . See Fig 1. |
| 3 | Disconnecting the electrical plug connection of the sun blind motor drive | Disconnect electrical plug connection (blue) -4A-4B- . See Fig 1. |
| 4 | Drilling the pop rivets out | Drill out the pop rivets -5- . See Fig 1. |
| Note! During removal, the metal guide tubes must not be bent or distorted! | ||
| 5 | Removing the metal guide tubes | Unscrew fastening screws -6-7-7- . See Fig 1. |
| 6 | Pulling out the mounting unit | Pull out the mount slide at the front -8-9-10- . See Fig 1. |