Additional instructions for fitting the inner panels

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Installing inner panels

Press the sides of the inner panel into the sliding roof frame. Check function by sliding longitudinally.

Fig 1: Pressing Sides Of Inner Panels Into Sliding Roof Frame
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Pull out the connector springs -B- on the gate and push in sliding/tilting roof trim. Push inner panels under the sheetmetal panel of the sliding/tilting roof trim.

Fig 2: Pulling Out Connector Springs
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Position the sliding/tilting roof trim -dimension A- approx. 80 mm in front of the roof edge cut-out.

Fig 3: Identifying Dimension For Positioning Sliding/Tilting Roof Trim
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Engage the left and right-hand inner side panels in the sliding/tilting roof trim. Repeat the procedure for installing the sliding roof panel.

Fig 4: Engaging Inner Side Panels In Sliding/Tilting Roof Trim
Courtesy of PORSCHE OF NORTH AMERICA, INC.