Installing roof module
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
ROOF MODULE COMPONENTS INSTALLING PROCEDURE - TARGA
| No. | Procedure | Instructions |
|---|---|---|
| 1 | Guiding in and fastening the roof module | 1. Tilt the roof module at the front diagonally to the right and guide it into the vehicle -direction of arrow A- and turn horizontally -B- . See Fig 1. |
| 2. Move the roof module forwards to the windscreen -arrow C- . See Fig 1. | ||
| 3. Pull the protective film off the Nito tape. | ||
| 4. Roof module in the fastening screws, see: Insert -centring X- at rear. See Fig 1. | ||
| 5. Insert centring pin -Y- into the roof frame at the front. See Fig 1. | ||
| 6. Fasten the roof module with three fastening screws on each side. | ||
| 2 | Screwing in fastening nuts | Screw in fastening nuts -9- . See Fig 1. |
| 3 | Screwing in fastening screws | Tighten the fastening screws -8- . See Fig 1. |
| 4 | Connecting electrical plug connection | Connect the electrical plug connection -7-direction of arrow B-direction of arrow A- . See Fig 1. |
| 5 | Connecting the rear water drainage | Connect the rear water drainage -3, 4-5-6- . See Fig 1. |
| 6 | Connecting the front water drainage | Connect the front water drainage -2- . See Fig 1. |
| Functional inspection | Connect the Porsche System Tester to the diagnostic socket. Switch on ignition. | |
| Select the menu item Targa roof, select the menu item drive links, open/close function or actuate rear lid function. | ||
| Read out fault memory. If necessary, in case of a fault entry, proceed according to | ||
| Refer to CONVERTIBLE TOP, HARDTOP - 911 CARRERA (996) . | ||
| Installing rear window cover | Refer to REMOVING AND INSTALLING REAR WINDOW COVER - TARGA . | |
| Installing front roof lining | Refer to REMOVING AND INSTALLING ROOF LINING, FRONT - TARGA . | |
| Installing sun visors | Refer to REMOVING AND INSTALLING ROOF LINING, FRONT - TARGA . | |
| Installing passenger compartment monitoring | Refer to REMOVING AND INSTALLING PASSENGER COMPARTMENT MONITORING SENSOR . | |
| Installing adjustment fitting (seat belt height adjuster) | Refer to REMOVING AND INSTALLING ADJUSTMENT FITTING (SEAT BELT HEIGHT ADJUSTER) . | |
| Installing rear three-point belt | Refer to REMOVING AND INSTALLING REAR THREE-POINT BELT . | |
| Installing side-panel lining | Refer to REMOVING AND INSTALLING SIDE-PANEL LINING - TARGA . | |
| Installing roof rail trim | Refer to REMOVING AND INSTALLING MEMBER TRIM -- TARGA, - AS OF MY 2002 . | |
| Installing trim of A, B and C-pillars | Refer to REMOVING AND INSTALLING A, B AND C-PILLARS - TARGA . | |
| Installing rear wall lining and rear wall upper part | Refer to REMOVING AND INSTALLING REAR WALL LINING - TARGA . |