Removing motor for sliding roof

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Using a small screwdriver, carefully unclip both cover lenses at the openings provided. Undo fastening screws with a crosshead screwdriver -arrow A- . See Fig 1.
Unclip cover at the rear left and right -arrow B- push forward towards the windscreen and remove. See Fig 1.

Fig 1: Removing Fastening Screws & Unclipping Cover

Courtesy of PORSCHE OF NORTH AMERICA, INC.

Unscrew both Torx T25 fastening screws -arrows- and take motor for sliding roof down and off the teeth.

Fig 2: Removing Motor For Sliding Roof Torx T25 Fastening Screws
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Push motor for sliding roof in the roof member trim to the side and take out to the bottom. Disconnect the electrical plug connection.