Removing the microswitch for the sliding roof > closed <

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Microswitch For Sliding Roof (Closed) - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE:

Mark position of the microswitch with coloured ink.

MICROSWITCH REMOVING PROCEDURE - TARGA

No.	Procedure	Instructions
1	Removing rear wall lining	Hold rear cover at the side underneath and carefully pull out of the clips in the -direction of arrow- . See Fig 1.
2	Folding closing aid over	Unscrew the fastening screws -1-inset- . See Fig 1.
3	Undoing microswitch plug connection	Turn the plug unit anti-clockwise and remove it from the body. -A-2-B- . See Fig 1.
3		Press the plugs together -A-2-B- . See Fig 1.
4	Removing microswitches	Unscrew fastening screw -3- . See Fig 1.