LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Sliding Roof - 911 CARRERA (996)) >> Removing and installing electric motor for sliding roof - Targa >> Installing right electric motor for sliding roof

Installing right electric motor for sliding roof

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing Right Electric Motor For Sliding Roof - Targa
G03055505Courtesy of PORSCHE OF NORTH AMERICA, INC.
NOTE: Check the shafts at the drive pipe bracket for chips.
RIGHT ELECTRIC MOTOR INSTALLING PROCEDURE - TARGA

No. Procedure Instructions
1 Installing roof motor Push the gear wheel of the electric motor -2-  . See Fig 1.
2 Connecting the plug connection Press the plug -3-  . See Fig 1.
3 Screwing the roof motor tighten Tighten the fastening screws -1-  . See Fig 1.
4 Installing rear wall lining Position cover and push on in direction of arrow until the pegs of the cover clip in.