Installing cowl panel cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Cowl Panel Cover - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

COWL PANEL COVER INSTALLING PROCEDURE - TARGA

No.	Procedure	Instructions
		Before installing the covers, the flanges of the body must be cleaned.
		See Tools and materials .
		Cut adhesive tape to a width of 5 mm and stick onto the cowl panel cover.
		See Tools and materials .
1	Installing cowl panel cover	Pull protective film off the bonding area.
2	Screwing in fastening screws	Move cowl panel cover -1-Section A-A-B-C-1-2- . See Fig 1.
3	Installing roof joint strip	Position the roof joint strip onto the sheetmetal lugs at the front and rear and move 1 cm in -direction of arrow A- . See Fig 1.