LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Sliding Roof - 911 CARRERA (996)) >> Removing and installing cover for sliding roof - Targa >> Installing cover for sliding roof >> Calibrating spacer sleeves

Calibrating spacer sleeves

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

If the installation position was not marked during removal or the spacer sleeves are no longer present, it is necessary to calibrate. See Tools and materials .

To do so, position all spacer sleeves in the frame for the sliding roof cover and install the sliding roof cover. Check the sliding roof cover according to the gap dimensions; if necessary re-install or calibrate the spacer sleeves, which vary by 11 - 15 mm. Refer to DIAGRAM - BODY GAP DIMENSIONS - TARGA .

scientia non olet · About LEMON Manuals