Disassembling frame for sliding roof

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disassembling Sliding Roof Frame

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE:

The following parts must be transferred from the sliding roof frame to be replaced to the new sliding roof frame: motor for sliding roof, draught deflector, frame clips.

SLIDING ROOF FRAME DISASSEMBLING PROCEDURE

No.	Procedure	Instructions
		Refer to REMOVING AND INSTALLING ROOF LINING .
		Refer to Removing and installing frame for sliding roof .
1	Remove draught deflector	Fold the draught deflector up, press it inwards and out of the guides at the left and right sides and pull it out.
2	Remove frame clips	Press in the left and right tabs of the frame clip -A- . See Fig 1.
3	Detach motor for sliding roof	Unscrew both Torx T25 fastening screws and take motor for sliding roof down and off the teeth of the sliding roof frame.
3	Detach motor for sliding roof	Refer to Removing and installing motor for sliding roof .