Assembling frame for sliding roof

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Assembling Sliding Roof Frame

Courtesy of PORSCHE OF NORTH AMERICA, INC.

SLIDING ROOF FRAME ASSEMBLING PROCEDURE

No.	Procedure	Instructions
1	Fit frame clips	Press the frame clips -A- . See Fig 1.
2	Fit motor for sliding roof	Position motor for sliding roof into the teeth of the frame. Screw in with the Torx T25 fastening screws and tighten. -6 Nm (4.5)- Tightening torque: -6 Nm (4.5)- Refer to Removing and installing motor for sliding roof . Refer to Re-teaching motor for sliding roof .
3	Fit draught deflector	Press the draught deflector in on the left and right and insert it into the guides at the sides. Fold up the draught deflector.