LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission, Controls, Case - 911 CARRERA (996)) >> Removing and installing Tiptronic control unit (as of MY 2002) >> Coding Tiptronic control module

Coding Tiptronic control module

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The adaptation values must be reset using the Porsche System Tester when the transmission is renewed/replaced.
  • If a new control module is installed, the control module must adapt first. Poor shifting quality can be expected therefore in the adaptation phase.
  • After the test drive, let the engine run for 10 minutes at idle speed. This ensures that all adaptation values are stored in the control module.
  • The instructions of the Porsche System Tester have highest priority.
  • The procedure listed has been structured generally, changes or additions can be made. The basis of this is the Tester Software 13.1.
  1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch ignition on.
  2. Select vehicle type using the cursor keys.
  3. Using the ">>" key, move from the vehicle type to the list of control modules.
  4. Select Tiptronic with the cursor keys and press the ">>" key.
  5. Select "Coding" with the cursor keys and press the ">>" key.
  6. Select vehicle version and code with the F8 key.
    SELECTION OF VEHICLE VERSION AND CODE

    Row/ Japan PA 1
    Taiwan/ Korea PA 4
  7. Tester confirmed: Coding has been modified  .
  8. Perform test drive and check fault memory with the System Tester.

    Resetting adaptation values. 

    • Proceed as described under point 1 - 4.
    • Select menu item Reset adaptation values proceed with ">>".
  9. Confirm with F7 for Yes, F8 for No and proceed with ">>".
  10. Follow the instructions of the tester.
scientia non olet · About LEMON Manuals