LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Wiring - 911 CARRERA (996)) >> Repair of rear wiring harness >> Removing rear wiring harness

Removing rear wiring harness

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery and cover terminal or battery.
  2. Undo combination wire in the area of the rear wheel housing.
  3. Remove trim of seat well and cover of rear side member.
  4. Undo rubber grommet, unclip combination wire on inside and open wiring duct.
  5. Uncover combination wire in the interior as far as plug connection X 2/4 and disconnect plug connection (do not damage any other wires).
scientia non olet · About LEMON Manuals