Repair of rear wiring harness: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The combination wires for ABS and BVA are integrated in the wiring harness. In the event of damage, the integrated wires can be removed and replaced by repair wires. The disconnection point is plug connector X 2/4 for the passenger compartment/rear end (yellow) or connection points. The plug connection is located behind the driver's seat, to the left, beneath the belt roller.
After repair, the following function tests must be performed:
ABS: test with the Porsche System Tester 2.
BVA: the indicator light must go out with the engine running and the brake linings intact.
Plug connection X 2/4, -(arrow)- passenger compartment/rear end: install preassembled contacts or join wires at connection points.

Fig 1: Locating Plug Connection
Courtesy of PORSCHE OF NORTH AMERICA, INC.