LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Wiring - 911 CARRERA (996)) >> Removing and installing fusible element in the current distributor >> Removing fusible element from the current distributor

Removing fusible element from the current distributor

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Danger of injury and risk of damage!
  • The battery must be clamped off before starting the assembly work.
  1. Remove cover for current distributor and remove the service label.
    Fig 1: Removing Cover For Current Distributor
    G03063716Courtesy of PORSCHE OF NORTH AMERICA, INC.
  2. Carefully lever off the cover -A-  , for example, with a screwdriver -arrow-  . This will break the locking tabs and the cover can be removed.
    3. Fig 2: Removing Current Distributor Cover With Screwdriver
    G03063717Courtesy of PORSCHE OF NORTH AMERICA, INC.
  3. Remove the broken locking tabs from the current distributor.
  4. Unscrew the two hexagon nuts M 5 -3-  from the blown fusible element -1-  and remove with the washer -2-  .
    5. Fig 3: Removing Nuts From Blown Fuse Element And Washer
    G03063718Courtesy of PORSCHE OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals